Installing Windows XP With F6 AHCI/RAID Drivers From USB Only

Installing Raid Drivers

Follow the instructions included with your motherboard. Do you already have an account? As I did several tries, I can not be sure what steps are necessary and what not, so I'll list everything I did. Below are the steps to accomplish the task. What is the role of moderators?

Then navigate to your driver, and intall it. There's a special software for that purpose called nLite. Leave the disk in the drive as Windows setup copies the files from the disk to the Windows installation folders. Windows Setup will find and install the correct driver automatically.

Hi, I have been facing this problem for a couple months now. Therefore, make sure that you follow these steps carefully.

Installing Windows XP With F6 AHCI/RAID Drivers From USB Only

How can I force Windows to install a driver, when the corresponding hardware is not present? Since you are booting using other controller, it's all hunky dory!

Important This section, method, or task contains steps that tell you how to modify the registry. If asked to restart again, restart computer. Exit all Windows-based programs.

Installing raid drivers

Windows 7 Installation RAID Drivers

Watch for the prompt to load support for mass storage devices. It asked me to reboot instead. Current visitors New profile posts Search profile posts Billboard Trophies.

Press S to Specify Additional Device. When you did it, it worked because the drivers were included in Windows. Windows may work with some Intel drivers.

Installing SATA RAID driver to existing Windows

Try installing Windows normally without loading any special drivers. Usually Windows drivers can be installed when installation of the Windows itself is complete. The reason this way doesn't work for disk drivers is because Windows must have access to the disk all the time during installation. Unable to uninstall drivers causing the issue.

After cloning drive, reboot computer. Set the Drive Mode option to Enhanced.

Anyway I think that wraps it up, try at your own risk and always backup first. It was actually not that difficult. Windows setup is ready to reboot.

Once it was in there, I could then boot from it. How do they differ from normal Windows drivers?

If cloning drive follow this step and skip the next step. The process is explained in detail in this article. Once there are no hardware installation prompts or restart notifications. Note, as always, I would highly recommend doing a full disk backup of your system before trying this, and at the very least back up your registry before editing it. Now that you have done your fresh installation.

When you make your changes and reboot, the driver will then be there for it to automatically find for the new device. Re-install is never an option! Press Enter to create the volume. May give that a go first once i find mine! Home Questions Tags Users Unanswered.

Otherwise, it will not install even when it get to the point it is looking for a drive. Setup is still loading drivers. The drivers are now installed. What's special about Text Mode Drivers? At what point exactly does the bsod occur during setup?

Is there something I'm doing wrong? The array isn't on the drive list.

1. What is AHCI/RAID drivers Who needs them

Windows already contains hundreeds of drivers for wide range of supported hardware, but not for everything, unfortunately. Used nLite to slipstream the drivers. New posts New profile posts Latest activity. However, serious problems might occur if you modify the registry incorrectly. Email Required, hp designjet 510 drivers for windows 7 but never shown.

Sometimes installing Windows can be a truly challenging problem. Question lost onedrive files after installing m. Question Installing windows to ssd.

For added protection, back up the registry before you modify it. Verify that your computer boots up and all hardware is installed and there are no prompts to restart. Previous Next Sort by votes. At the prompt, press Y to confirm the volume creation. New posts Trending Search forums.

After booting up you should receive no hardware installation prompts. Any other ideas why it might not work? After you boot, as in this case, you can just add the driver as I described, and then even if you change the disk configuration, it will find the right driver because you added it that way. Evidently, but I'm not sure what it is.

Installing the Operating System onto a RAID Volume F6 Install Method